Mold Watering/ Heating: Key of Process Control

images

By Garrett MacKenzie

When trying to establish process control in plastic injection, watering the tool is a key variable that is often overlooked. Water set-up and design are every bit as important as establishing and recording a repeatable process. The steps taken when watering a mold are key to a processor’s goal of consistency. If during the design and development stage, watering is put on the back burner as an “unimportant” variable, the potential for lost process control is huge. 

Below are some insights into the most important facets of cooling or heating your mold, as well as what recordable data are important in the initial stages of process engineering…

Click HERE to read the article